1. First diluent (or banana water) into the gun pull the trigger after the tank coherent, will be remaining in the paint spray gun, preferably twice. 2. With a brush and cloth to the outer surface of the body paint gun clean of impurities. 3, the gun should be kept clean, non-residual solvents, but not the air cover (tips) into the solvent, due to thinner containing xylene, toluene, butyl, ethyl, CAC and other solvents, thinner, more poormixture may contain benzene, ketones, ethers, solvents, such as alkaline electroplating parts, aluminum, plastic mats, which are corrosive. 4, maintaining the same gun to the air compressor (to play pump) and routine pipeline maintenance and cleaning, or air compressor oil, water and impurities will enter the gun with the gas pipeline, causing obstruction and painting paint contamination. 5, routine maintenance is completed, the basic overall decomposition does not need cleaning.
Linked with the flow and leveling with paint when the paint on the viscosity, thinner by adding a large amount of low viscosity paints, leveling is good, but easy to flow when the jet set things to hang; the other hand, thinner add less, paint high viscosity, poor leveling, but the elevation is not easy to sag. In addition, spraying, big gun out of fuel, gun too close to the gun moving slowly, spraying susceptible to sagging facades; gun oil less, pneumatic big guns too far away, the gun moving speed of spraying leveling. Film thickness, easy leveling, sagging facades and easy; coating is thin, not sagging, but it is difficult leveling; dry fast, hard leveling, do not sag; dry slower speed, leveling, easy sag .
If you want to understand the common problems for the spray solution, you can see what the gun used in the instructions.
Permalink: http://www.airpaintandtools.com
For more info. on spray gun|Airbrush
| Hvlp Spray Gun